Easy and virtually free patchwork quilt – Part 8 THE END!

Binding

At last - we are at the final stage!

Read part 1
Read part 2
Read part 3
Read part 4
Read part 5
Read part 6
Read part 7

This is the kind of thing that is so easy to show but very hard to describe, so I've drawn little diagrams to try and explain. There are lots of different ways of binding the edges of your quilts. I am showing you this way because it is totally machine sewn, therefore very fast, and doesn't involve tricky mitred corners.

First cut your 2 inch wide binding strips. Don't use a very thick fabric for this. Use a light cotton, maybe some of your left over sheet backing. Fold the strips as follows:

Iron the creases in really well. Open out the strip again and position it as shown

Turn over the quilt and fold back the binding strip along the fist crease, like this:
Fold in the right hand edge, and then fold it over again down the centre crease. Sew through the whole lot as neatly as you can close the the folded edge of the binding. Trim off the ends. Thats one side done! Repeat on the opposite side of the quilt

For the other 2 sides position the binding strip as before, (face down on the wrong side of the quilt) but this time with 1/2 an inch extra at the ends.

Again, turn over the quilt and fold back the strip

To neaten up the edges, fold in the ends like this:

As before, fold in the right hand edge, the fold again to close up the binding. Sew close to the folded edge. The corners will be bulky so go slowly and don't panic.

Other binding tips:

Use up scraps by sewing together off-cuts, then cutting out the 2 inch strips.

I never pin, but fold and position as I go. Try it and see.

Percieved wisdom says that your binding should be darker in colour that your quilt top, but I don't heed this advice. I use up scraps, or go for a contratsting colour to create a frame.

If you don't like the effect with the stitching on the front face then the traditional way of binding is to place the strip face down on the right side of the quilt first, sew down the crease, then turn it over, fold in the edges, and hand sew it down. You can do mitres too but I don't usually bother unless it's a really special quilt.

So - thats it! You've finished your quilt. That wasn't too hard was it!